Subaru LEGACY 2006 Manual page 3713

asieps_tobira.book 40 ページ ２００９年１０月２６日 月曜日 午前９時１６分
CONTROL SYSTEMS
10) Install a new lock wire.
(A) Lock wire
NOTE:
• Install the lock wire to the stay groove.
• Bend the extra wire to the same direction of lock
wire winding.
(A)
B
(B)
B - B
(A) Inner boot
(B) Lock wire
(C) Stay
MT Gear Shift Lever
E: INSPECTION
1) Check the parts (bushing, cushion rubber, spac-
er, boot, stay and rod, etc.) for deformation, dam-
age and wear. If necessary, repair or replace faulty
parts. Compare the removed parts with new parts
to judge if there are damages or not.
(A)
CS-00316
(A)
B
(B)
(C)
2) Check the swing torque of rod linked with the
(B)
gear shift lever.
If the torque exceeds the specifications, replace the
bushing or retighten nuts.
CS-00240
Swing torque:
Less than 3.7 N (0.38 kgf, 0.84 lb)
CS-40
(C)
(F)
(A)
(C)
(A)
(C)
(D)
(E)
(A) Bushing
(B) Cushion rubber
(C) Spacer
(D) Boot
(E) Stay
(F) Rod
(A)
(B)
(A) Pivot
(B) Swing torque
(A)
(B)
CS-00323
CS-00116