Subaru LEGACY 2006 Manual page 4106

asieps_tobira.book 8 ページ ２００９年１０月２６日 月曜日 午前９時１６分
TIRE PRESSURE MONITORING SYSTEM (DIAGNOSTICS)
5. Subaru Select Monitor
A: OPERATION
1. READ DIAGNOSTIC TROUBLE CODE
(DTC)
1) Prepare the Subaru Select Monitor kit. <Ref. to
TPM(diag)-4, SPECIAL TOOL, PREPARATION
TOOL, General Description.>
2) Connect the diagnosis cable to the Subaru Se-
lect Monitor.
3) Insert the cartridge to the Subaru Select Monitor.
<Ref. to TPM(diag)-4, SPECIAL TOOL, PREPA-
RATION TOOL, General Description.>
4) Connect the Subaru Select Monitor to the data
link connector.
(1) The data link connector is located in the low-
er portion of the instrument panel (on the driv-
er's side).
(1)
(1) Data Link Connector
Subaru Select Monitor
(2) Connect the diagnosis cable to the data link
connector.
CAUTION:
Do not connect scan tools other than the Suba-
ru Select Monitor.
5) Turn the ignition switch to ON (engine OFF) and
turn the Subaru Select Monitor switch ON.
ABS00111
(1) Power switch
6) On the «Main Menu» display screen, select
{Each System Check} and press the [YES] key.
7) On the «System Selection Menu» display
screen, select the {Tire Pressure Monitor} and
press the [YES] key.
8) Press the [YES] key after the {Model Year} is
displayed.
9) On the «Tire Pressure Monitor Diagnosis»
screen, select the {DTC Display}, and then press
the [YES] key.
NOTE:
• For details concerning the operation procedures,
refer to the "SUBARU SELECT MONITOR OPER-
ATION MANUAL".
ABS00112
• For details concerning DTCs, refer to List of Di-
agnostic Trouble Codes (DTC). <Ref. to TPM(di-
ag)-27, List of Diagnostic Trouble Code (DTC).>
• All DTCs detected will be dispayed.
• If a particular DTC is not properly stored in mem-
ory (due to a voltage drop of the tire air pressure
monitor control module power supply, etc.) when a
problem occurs, a DTC suffixed with a question
mark will appears on the Subaru Select Monitor
display. This shows it may be an unreliable read-
ing.
10) If communication is not possible between the
tire pressure monitoring control module and the
Subaru Select Monitor, check the communication
circuit. <Ref. to TPM(diag)-11, COMMUNICATION
FOR INITIALIZING IMPOSSIBLE, INSPECTION,
ABS00465
Subaru Select Monitor.>
11) When DTC is not displayed, check the indicator
circuit and communication circuit. <Ref. to TPM(di-
ag)-14, WITHOUT DTC, INSPECTION, Subaru
Select Monitor.>
TPM(diag)-8
(1)
ABS00114