Subaru LEGACY 2006 Manual page 4087

asieps_tobira.book 10 ページ ２００９年１０月２６日 月曜日 午前９時１６分
REAR SUSPENSION
11) Remove the nuts which hold the rear arm to
bracket. Remove the rear arm bracket.
12) Loosen the nut which holds the front link to the
rear arm.
13) Loosen the nut which holds the rear link to the
rear arm.
Rear Arm
14) Loosen the nut which holds the upper link to the
rear arm.
15) Remove the bolt which secures the rear arm to
the link, and then remove the rear arm.
B: INSTALLATION
NOTE:
Use a new bolt and self-locking nut. For parts which
are not reusable, refer to "COMPONENT". <Ref. to
RS-3, REAR SUSPENSION, COMPONENT, Gen-
eral Description.>
1) Support the rear arm using a transmission jack.
2) Install the rear arm and temporarily tighten the
RS-00118
bolts which hold the rear arm to the link.
3) Install the bearing unit.
<Ref. to DS-20, INSTALLATION, Rear Hub Unit
Bearing.>
4) Install the bolts which secure the ABS wheel
speed sensor to rear arm.
5) Install the bolts which secure the brake hose to
the rear arm.
6) Install bolts which secure the parking brake ca-
ble clamp to the rear arm bracket.
7) Set the vehicle equipped jack upside down, be-
tween the rear link and sub frame. Align the loca-
tion of the jack, and with the rear shock absorber
RS-00048
and rear arm attachment locations matched, tem-
porarily tighten the bolt and nut.
CAUTION:
Protect the rear link and sub frame from being
damaged by putting a waste cloth between the
contact surface with the jack.
RS-00049
8) Support the rear arm horizontally using a trans-
mission jack.
RS-10
RS-00050
RS-00051