Subaru LEGACY 2006 Manual page 3285

asieps_tobira.book 41 ページ ２００９年１０月２６日 月曜日 午前９時１６分
32) Install the rear exhaust pipe and muffler as-
sembly.
<Ref. to EX(H4SO)-8, INSTALLATION, Rear Ex-
haust Pipe.> <Ref. to EX(H4SO)-10, INSTALLA-
TION, Muffler.>
33) Install the front and center exhaust pipe.
<Ref. to EX(H4SO)-5, INSTALLATION, Front Ex-
haust Pipe.>
34) Install the under cover.
35) Lower the lift.
36) Install the ATF level gauge.
37) Connect the following connectors.
(1) Transmission harness connectors
(2) Transmission ground terminal
38) Install the air cleaner case stay.
Tightening torque:
16 N·m (1.6 kgf-m, 11.6 ft-lb)
39) Install the air intake chamber.
<Ref. to IN(H4SO)-7, INSTALLATION, Air Intake
Chamber.>
40) Install the air intake duct.
<Ref. to IN(H4SO)-8, INSTALLATION, Air Intake
Duct.>
41) From the gauge hole, add ATF until the fluid
level is between the upper and lower level on the
"COLD" side of the level gauge. <Ref. to 4AT-26,
Automatic Transmission Fluid.>
42) Take off the vehicle from lift.
43) Check the differential gear oil level. <Ref. to
4AT-28, Differential Gear Oil.>
44) Check the select lever operation.
<Ref. to 4AT-46, INSPECTION, Inhibitor Switch.>
45) Bleed the air of control valve. <Ref. to 4AT-60,
Air Bleeding of Control Valve.>
46) Check the ATF level. <Ref. to 4AT-26, Auto-
matic Transmission Fluid.>
47) Execute the learning control promotion. <Ref.
to 4AT(diag)-16, FACILITATION OF LEARNING
CONTROL, OPERATION, Subaru Select Moni-
tor.>
48) Perform the road test.
<Ref. to 4AT-29, Road Test.>
Automatic Transmission Assembly
AT-01330
4AT-41
AUTOMATIC TRANSMISSION