Subaru LEGACY 2006 Manual page 3699

asieps_tobira.book 22 ページ ２００９年１０月２６日 月曜日 午前９時１６分
CONTROL SYSTEMS
13) Disconnect the terminals of the SPORT mode
switch and shift lock solenoid assembly from the
connector, using a flat-tip screwdriver with a thin
tip.
(A) "P" range switch
14) Remove the cable bracket.
15) Remove the cover.
16) Remove the select lever assembly.
Select Lever
17) Remove the clamp, and remove the arm as-
sembly and bushing plate.
(A)
4 3 2 1
10 9 8 7 6 5
CS-00529
D: ASSEMBLY
1) Clean all the parts before assembly.
2) Apply grease [Multemp AC-D or equivalent] to
each part. <Ref. to CS-2, AT SELECT LEVER,
COMPONENT, General Description.>
3) Assemble in the reverse order of disassembly.
NOTE:
• Refer to "COMPONENT" for each tightening
torque. <Ref. to CS-2, AT SELECT LEVER, COM-
PONENT, General Description.>
CS-00530
• Connect the switch terminal to the connector.
CS-00531
4) After completing installation, shift the select le-
ver from "P" range to "D" range, then check wheth-
er the indicator and select lever matches, whether
the pointer and position mark matches and what
the operating force is.
E: INSPECTION
1) Inspect the removed parts by comparing with
new parts for deformation, damage and wear. Re-
pair or replace if defective.
CS-00532
2) Confirm the select lever operating condition be-
fore assembly. Normal if it operates smoothly.
CS-22
(A)
(C)
(B)
(D)
(C)
(A) Arm ASSY
(B) Bushing plate
(C) Bushing A
(D) Bushing B
4
10
(A) "P" range switch
CS-00686
(A)
3 2 1
9 8 7 6 5
CS-00529