Subaru LEGACY 2006 Manual page 3360

asieps_tobira.book 90 ページ ２００９年１０月２６日 月曜日 午前９時１６分
AUTOMATIC TRANSMISSION
2) Secure the case in a vise, remove the hypoid
driven gear tightening bolts, and then separate the
hypoid driven gear into case (RH) and case (LH).
(A) Hypoid driven gear
(B) Differential case (RH)
(C) Differential case (LH)
3) Pull out the straight pin and shaft, and then re-
move the differential bevel gear, washer and differ-
ential bevel pinion.
(A) Differential case (RH)
2. SIDE RETAINER
NOTE:
After adjusting the drive pinion backlash and tooth
contact, remove and install the oil seal and O-ring.
1) Remove the O-ring.
Front Differential Assembly
(A)
(B)
(C)
AT-00217
(A)
AT-00218
AT-00219
5AT-90
2) Remove the oil seal.
3) Remove the split pin, and then remove the claw.
ST 398527700 PULLER ASSY
(A) Claw
(B) Split pin
(C) Pin
4) Attach two claws to the outer race, and set the
ST to side retainer.
ST 398527700 PULLER ASSY
(A) Shaft
(B) Claw
5) Restore the removed claws to original position,
and install the pin and split pin.
MT-01454
AT-00221
AT-00222