Subaru LEGACY 2006 Manual page 3359

asieps_tobira.book 89 ページ ２００９年１０月２６日 月曜日 午前９時１６分
35.Front Differential Assembly
A: REMOVAL
1) Remove the transmission assembly from vehicle
body. <Ref. to 5AT-34, REMOVAL, Automatic
Transmission Assembly.>
2) Pull out the torque converter assembly. <Ref. to
5AT-63, REMOVAL, Torque Converter Assembly.>
3) Remove the transmission harness connector
from stay.
4) Remove the oil charge pipe. <Ref. to 5AT-62,
REMOVAL, Oil Charge Pipe.>
5) Remove the ATF filter inlet and outlet pipes.
<Ref. to 5AT-55, REMOVAL, ATF Filter.>
6) Separate the converter case from the transmis-
sion case. <Ref. to 5AT-78, REMOVAL, Converter
Case.>
7) Remove the differential side retainers using ST.
NOTE:
Hold the differential case assembly by hand to
avoid damaging the retainer mounting hole of the
converter case.
ST 18630AA010 WRENCH COMPL RETAIN-
ER
8) Remove the differential assembly while being
careful not to damage the attachment part of retain-
er.
B: INSTALLATION
1) When installing the differential assembly to
case, be careful not to damage the inside of case
(particularly, the differential side retainer mating
surface).
(A)
(A) Differential ASSY
2) Install the O-ring to left and right side retainer.
3) Using the ST, install the side retainer. <Ref. to
5AT-89, REMOVAL, Front Differential Assembly.>
ST 18630AA010 WRENCH COMPL RETAIN-
ER
4) Adjust the backlash of the front differential. <Ref.
to 5AT-92, ADJUSTMENT, Front Differential As-
sembly.>
Front Differential Assembly
5) Install the lock plate.
Tightening torque:
25 N·m (2.5 kgf-m, 18 ft-lb)
6) Install the converter case to the transmission
case. <Ref. to 5AT-78, INSTALLATION, Converter
Case.>
7) Install the transmission harness connector to the
stay.
8) Install the ATF filter pipe. <Ref. to 5AT-55, IN-
STALLATION, ATF Filter.>
9) Install the oil charge pipe together with an O-
ring. <Ref. to 5AT-62, INSTALLATION, Oil Charge
Pipe.>
10) Install the torque converter assembly. <Ref. to
5AT-63, INSTALLATION, Torque Converter As-
sembly.>
11) Install the transmission assembly to the vehi-
cle. <Ref. to 5AT-37, INSTALLATION, Automatic
Transmission Assembly.>
C: DISASSEMBLY
1. DIFFERENTIAL CASE ASSEMBLY
1) Remove the taper roller bearing using the ST
and a press.
ST 498077000
AT-01987
5AT-89
AUTOMATIC TRANSMISSION
(A) Lock plate
REMOVER
(A)
AT-01988
AT-00216