Subaru LEGACY 2006 Manual page 3789

asieps_tobira.book 74 ページ ２００９年１０月２６日 月曜日 午前９時１６分
MANUAL TRANSMISSION AND DIFFERENTIAL
C: INSPECTION
1) Move the reverse shifter rod toward the reverse
side. Check the clearance between the reverse
idler gear and the timing case wall surface.
If out of specification, select an appropriate reverse
shifter lever and adjust.
Clearance A:
6.0 — 7.5 mm (0.236 — 0.295 in)
A
2) After installing a suitable reverse shifter lever,
shift into neutral. Check the clearance between the
reverse idler gear and the timing case wall surface.
If out of specification, select the appropriate washer
and adjust.
Clearance:
0 — 0.5 mm (0 — 0.020 in)
3) Check the reverse idler gear and shaft for dam-
age. Replace if it is damaged.
Reverse Idler Gear
D: ADJUSTMENT
1) Select the appropriate reverse shifter lever from
the table below, and adjust until the clearance be-
tween the reverse idler gear and transmission case
wall is within specification.
Clearance A:
6.0 — 7.5 mm (0.236 — 0.295 in)
MT-00305
Part number
32820AA070
32820AA080
32820AA090
2) Select the appropriate washer from the table be-
low, and adjust until the clearance between the re-
verse idler gear and transmission case wall is
within specification.
Clearance:
0 — 0.5 mm (0 — 0.020 in)
MT-00306
Part number
803020151
803020152
803020153
803020154
803020155
5MT-74
A
MT-00305
Reverse shifter lever
Mark Remarks
7 Far from case wall
8 Standard
9 Closer to case wall
MT-00306
Washer
Thickness mm (in)
0.4 (0.016)
1.1 (0.043)
1.5 (0.059)
1.9 (0.075)
2.3 (0.091)