Subaru LEGACY 2006 Manual page 3357

asieps_tobira.book 87 ページ ２００９年１０月２６日 月曜日 午前９時１６分
F: ADJUSTMENT
1) Remove the liquid gasket from the mating sur-
face completely.
2) Install the converter case to oil pump cover, and
secure them with tightening four bolts evenly.
NOTE:
Use an old gasket or aluminum washer to prevent
damaging the mating surface of the housing.
Tightening torque:
41 N·m (4.2 kgf-m, 30.4 ft-lb)
3) Rotate the drive pinion a few times using ST1
and ST2.
ST1 18667AA010 HOLDER
ST2 499787700 WRENCH
ST1
4) Adjust the drive pinion and hypoid driven gear
backlash. <Ref. to 5AT-92, ADJUSTMENT, Front
Differential Assembly.>
5) Apply red lead evenly to the surfaces of three or
four teeth on hypoid driven gear. Rotate the drive
pinion in the leftward and rightward for several
times. Remove the oil pump cover, and check the
tooth contact pattern.
If the teeth contact is inappropriate, adjust the
backlash or thickness of the shim. <Ref. to 5AT-92,
ADJUSTMENT, Front Differential Assembly.>
• Correct tooth contact
Check item: Tooth contact surface is slightly
shifted toward the toe side under a no-load con-
dition. (When driving, it moves towards the heel
side.)
(A) Toe side
(B) Heel side
Drive Pinion Shaft Assembly
ST2
AT-01985
(A)
(B)
MT-01401
5AT-87
AUTOMATIC TRANSMISSION
• Face contact
Checking item: Backlash is too large.
Contact pattern
Corrective action: Increase thickness of pinion
height adjusting washer according to the proce-
dures for moving the drive pinion closer to the driv-
en gear.
• Flank contact
Checking item: Backlash is too small.
Contact pattern
AT-00208
AT-00212
AT-00209