Subaru LEGACY 2006 Manual page 3767

asieps_tobira.book 26 ページ ２００９年１０月２６日 月曜日 午前９時１６分
MANUAL TRANSMISSION AND DIFFERENTIAL
24) Place the transmission jack under the transmis-
sion.
CAUTION:
Always support the transmission case with a
transmission jack.
25) Remove the transmission rear crossmember
from the vehicle.
26) Remove the transmission.
NOTE:
1. Move the transmission jack towards the rear un-
til the main shaft is withdrawn from the clutch disc.
2. Tighten the turnbuckle of the ST while lowering
the transmission jack, to tilt the engine assembly
towards the back.
27) Separate the transmission assembly from the
rear cushion rubber.
Manual Transmission Assembly
B: INSTALLATION
1) Install the rear cushion rubber to the transmis-
sion assembly.
Tightening torque:
35 N·m (3.6 kgf-m, 26 ft-lb)
2) Install the transmission onto the engine.
NOTE:
Be careful not to hit the main shaft against the
clutch housing cover.
3) Install the transmission rear crossmember.
MT-00078
Tightening torque:
T1: 75 N·m (7.6 kgf-m, 55 ft-lb)
T2: 140 N·m (14.3 kgf-m, 103 ft-lb)
MT-00079
4) Take out the transmission jack.
5) Tighten the nuts which hold the lower side of the
transmission to the engine.
Tightening torque:
50 N·m (5.1 kgf-m, 36.9 ft-lb)
5MT-26
(1) Lift-up the transmission gradually using a
transmission jack.
(2) Loosen the turnbuckle of ST to return the
engine to its original position.
(3) Engage at the spline section.
T 1
T 2
T 1
T 2
MT-00081
MT-00077