Subaru LEGACY 2006 Manual page 4015

asieps_tobira.book 45 ページ ２００９年１０月２６日 月曜日 午前９時１６分
7. Oil Pump
A: REMOVAL
1. H4 MODEL
1) Disconnect the ground cable from battery.
2) Remove the air
IN(H4DOTC)-9, REMOVAL, Air Intake Duct.>
<Ref. to IN(H4SO)-8, REMOVAL, Air Intake Duct.>
3) Remove the pulley belt cover.
4) Loosen the belt tension securing bolt and gener-
ator securing bolt, then remove the power steering
pump V-belt.
5) Disconnect the connector from the power steer-
ing pressure switch.
6) Disconnect the pressure hose and suction hose
from the oil pump.
CAUTION:
• Do not allow fluid to come into contact with
the pulley belt.
• To prevent foreign matter from entering the
hose and pipe, cover the open ends with clean
cloth.
• Non-turbo model
(1)
(2)
(1) Suction hose
(2) Pressure hose
Oil Pump
intake duct. <Ref. to
PS-00461
PS-00688
PS-45
POWER ASSISTED SYSTEM (POWER STEERING)
• Turbo model
(1)
(2)
(1) Suction hose
(2) Pressure hose
7) Remove the installation bolt of the power steer-
ing pump bracket.
8) Place the oil pump bracket in a vise, and remove
the two bolts from the front side of the oil pump.
CAUTION:
When securing the oil pump bracket in a vice,
hold the oil pump bracket with the least possi-
ble force between two pieces of wood.
9) Remove the bolt from the rear side of oil pump.
PS-00459
PS-00188
PS-00128