Subaru LEGACY 2006 Manual page 3786

asieps_tobira.book 40 ページ ２００９年１０月２６日 月曜日 午前９時１６分
MANUAL TRANSMISSION AND DIFFERENTIAL
10.Transfer Drive Gear
A: REMOVAL
1) Remove the manual transmission assembly
from the vehicle. <Ref. to 5MT-24, REMOVAL,
Manual Transmission Assembly.>
2) Remove the back-up light switch and neutral po-
sition switch. <Ref. to 5MT-33, REMOVAL, Switch-
es and Harness.>
3) Remove the transfer case together with the ex-
tension case assembly. <Ref. to 5MT-36, REMOV-
AL, Transfer Case
Assembly.>
4) Remove the extension case assembly.
5) Remove the transfer driven gear.
6) Remove the transfer drive gear.
B: INSTALLATION
1) Attach the transfer drive gear.
Tightening torque:
26 N·m (2.7 kgf-m, 20 ft-lb)
2) Install the transfer driven gear.
3) Install the extension case assembly.
4) Install the transfer case and the extension case
assembly. <Ref. to 5MT-36, INSTALLATION,
Transfer Case and Extension Case Assembly.>
5) Install the back-up light switch and the neutral
position switch. <Ref. to 5MT-33, INSTALLATION,
Switches and Harness.>
6) Install the manual transmission assembly to the
vehicle. <Ref. to 5MT-26, INSTALLATION, Manual
Transmission Assembly.>
Transfer Drive Gear
and Extension Case
MT-00133
MT-00133
5MT-40
C: DISASSEMBLY
1) Remove the snap ring.
2) Remove the ball bearing.
D: ASSEMBLY
1) Set the ST against the inner race of the bearing,
and install the drive shaft.
ST 398177700 INSTALLER
NOTE:
Do not apply pressure in excess of 10 kN (1 ton, 1.1
US ton, 1.0 Imp ton).
2) Install the snap ring on the transfer drive shaft.
3) Inspect the clearance between the snap ring and
the ball bearing. <Ref. to 5MT-41, INSPECTION,
Transfer Drive Gear.>
MT-00135
MT-00136
ST
MT-00137