Subaru LEGACY 2006 Manual page 3362

asieps_tobira.book 92 ページ ２００９年１０月２６日 月曜日 午前９時１６分
AUTOMATIC TRANSMISSION
6) Using the ST, install the taper roller bearing.
ST 398487700 DRIFT
2. SIDE RETAINER
NOTE:
Install the oil seal and O-ring of side retainer after
the adjustment of backlash and tooth contact.
1) Install the bearing outer race to side retainer.
2) Install a new oil seal using ST.
ST 18675AA000 DIFFERENTIAL SIDE OIL
SEAL INSTALLER
NOTE:
Apply oil to the oil seal lips.
ST
3) Install a new O-ring.
E: INSPECTION
• Check each component for scratches, damage
or other faults.
• Measure the backlash, and then adjust it to be
within specification.
<Ref. to 5AT-92, ADJUSTMENT, Front Differential
Assembly.>
Front Differential Assembly
F: ADJUSTMENT
1) Using the ST, screw-in the retainer until resis-
tance is felt.
NOTE:
Screw-in the RH side slightly deeper than the LH
side.
ST 18630AA010 WRENCH ASSY
2) Remove the oil pump cover.
3) Remove the liquid gasket from the mating sur-
face completely.
4) Install the oil pump cover to converter case, and
secure them with tightening four bolts evenly.
AT-00226
NOTE:
Use an old gasket or aluminum washer to prevent
damaging the mating surface of the housing.
Tightening torque:
41 N·m (4.2 kgf-m, 30.4 ft-lb)
5) Rotate the drive pinion ten times or more using
ST1 and ST2.
ST1 18667AA010 HOLDER
ST2 499787700
AT-00219
5AT-92
ST
AT-00227
WRENCH
ST1 ST2
AT-01985