Subaru LEGACY 2006 Manual page 3890

asieps_tobira.book 71 ページ ２００９年１０月２６日 月曜日 午前９時１６分
Corrective action: Reduce the thickness of pinion
height adjusting washer according to the procedure
for bringing drive pinion away from hypoid driven
gear.
• Heel contact (outside end contact)
Check item: Contact area is small
Contact pattern
Corrective action: Increase thickness of drive pin-
ion height adjusting washer in order to bring drive
pinion close to hypoid driven gear.
20) If proper tooth contact is not obtained, once
again adjust the drive pinion height and the differ-
ential side bearing preload (already mentioned)
and the hypoid gear backlash.
Rear Differential (VA-type)
21) Install the new gasket and rear cover to the dif-
ferential carrier, and tighten the bolts to specified
torque.
Tightening torque:
34 N·m (3.5 kgf-m, 25.1 ft-lb)
AT-00213
AT-00211
AT-00212
DI-71
DIFFERENTIALS
DI-00387