Subaru LEGACY 2006 Manual page 3944

asieps_tobira.book 20 ページ ２００９年１０月２６日 月曜日 午前９時１６分
DRIVE SHAFT SYSTEM
NOTE:
If it is hard to remove, use the ST.
ST1 926470000 AXLE SHAFT PULLER
ST2 927140000 AXLE SHAFT PULLER
PLATE
ST1
B: INSTALLATION
1) Aligning the hub unit bearing to the mounting
hole of the back plate, install the hub unit assembly
and back plate. Tighten the axle nut temporarily.
CAUTION:
• Be careful not to damage the magnetic en-
coder.
• Do not get closer the tool which charged
magnetism to magnetic encoder.
(1) Magnetic encoder
(2) Rear hub unit bearing
Rear Hub Unit Bearing
2) Tighten the four bolts to the back plate.
Tightening torque:
65 N·m (6.6 kgf-m, 47.9 ft-lb)
ST2
3) Remove the axle nut.
DS-00122
4) Draw the rear drive shaft into specified position.
5) Tighten the new axle nut temporarily.
CAUTION:
Use a new axle nut (olive color).
6) Install the disc rotor to hub.
7) Install the disc brake caliper on the back plate.
Tightening torque:
53 N·m (5.4 kgf-m, 39.1 ft-lb)
(2)
(1)
8) Install the rear ABS wheel speed sensor and
DS-00251
brake cable bracket.
9) Adjust the parking brake lever stroke by turning
the adjuster. <Ref. to PB-4, ADJUSTMENT, Park-
DS-00151
ing Brake Lever.>
DS-20
DS-00149
DS-00152
DS-00147