Subaru LEGACY 2006 Manual page 3350

asieps_tobira.book 71 ページ ２００９年１０月２６日 月曜日 午前９時１６分
29.Reduction Driven Gear
A: REMOVAL
1) Remove the transmission assembly from vehicle
body. <Ref. to 5AT-34, REMOVAL, Automatic
Transmission Assembly.>
2) Remove the rear wheel speed sensor, and sep-
arate the extension case from transmission case.
<Ref. to 5AT-65, REMOVAL, Extension Case.>
3) Remove the center differential carrier. <Ref. to
5AT-74, REMOVAL, Center Differential Carrier.>
4) Set the range select lever to the "P" range.
5) Using ST1, ST2 and ST3, pull out the reduction
driven gear.
ST1 499737100 PULLER SET
ST2 18680AA010 GEAR HOLDER
ST3 18766AA000 SUPPORT PULLER
ST2
ST1
(A) Reduction driven gear
B: INSTALLATION
1) Set the range select lever to the "P" range.
2) Use a plastic hammer to install reduction driven
gear assembly.
3) Select the reduction gear shims. <Ref. to 5AT-
72, ADJUSTMENT, Reduction Driven Gear.>
4) Join the transmission case and the extension
case, and then install the rear vehicle speed sen-
sor. <Ref. to 5AT-65, INSTALLATION, Extension
Case.>
5) Install the transmission assembly to the vehicle.
<Ref. to 5AT-37, INSTALLATION, Automatic
Transmission Assembly.>
Reduction Driven Gear
(A)
ST2
ST3
AT-03271
5AT-71
AUTOMATIC TRANSMISSION
C: DISASSEMBLY
1) Remove the ball bearing from reduction driven
gear using ST.
ST 498077300 REMOVER
(A)
(A) Ball bearing
2) Remove the ball bearing on the reverse side with
the same procedure as step 1).
ST 498077300 REMOVER
(A)
(A) Ball bearing
3) Remove the snap ring of the parking gear.
ST
AT-00157
ST
AT-01969
AT-03264