Subaru LEGACY 2006 Manual page 3659

asieps_tobira.book 18 ページ ２００９年１０月２６日 月曜日 午前９時１６分
CLUTCH SYSTEM
6. Master Cylinder
A: REMOVAL
1) Thoroughly drain the brake fluid from the reser-
voir tank.
2) Remove the snap pin and clevis pin, and then
separate the push rod of the master cylinder from
clutch pedal.
(D)
(C)
(A) Clevis pin
(B) Snap pin
(C) Push rod
(D) Lock nut
3) Remove the air intake chamber. <Ref. to
IN(H4SO)-7, REMOVAL, Air Intake Chamber.>
4) Remove the clutch pipe from the master cylin-
der.
5) Remove the master cylinder and reservoir tank
as a unit.
CAUTION:
Be careful not to spill the brake fluid. Brake flu-
id spilled on the vehicle body will harm the
paint surface; wipe off quickly if spilled.
(B)
(A) Master cylinder ASSY
(B) Clutch pipe
Master Cylinder
(A)
(B)
CL-00042
(A)
CL-00152
CL-18
B: INSTALLATION
1) Install the master cylinder to the vehicle body,
and connect the clutch pipe to the master cylinder.
NOTE:
Check that the pipe is routed properly.
Tightening torque:
T1: 15 N·m (1.5 kgf-m, 10.8 ft-lb)
T2: 18 N·m (1.8 kgf-m, 13.0 ft-lb)
T2
2) Connect the push rod of the master cylinder to
the clutch pedal, and install the clevis pin and snap
pin.
NOTE:
Apply grease to the clevis pin.
(A)
(C)
(A) Clevis pin
(B) Snap pin
(C) Push rod
3) After bleeding air from the clutch system, ensure
that the clutch operates properly.
<Ref. to CL-22, Clutch Fluid Air Bleeding.>
4) Install the air intake chamber. <Ref. to
IN(H4SO)-7, INSTALLATION, Air Intake Cham-
ber.>
T1
CL-00153
(B)
CL-00045