Subaru LEGACY 2006 Manual page 3876

asieps_tobira.book 57 ページ ２００９年１０月２６日 月曜日 午前９時１６分
7) Fit a new oil seal with ST.
NOTE:
• Press-fit until the oil seal end comes 1 mm
(0.0394 in) inward from end of carrier.
• Apply grease to the oil seal lips.
ST 498447120 INSTALLER
ST
8) Press-fit the companion flange with ST1 and
ST2.
NOTE:
Be careful not to damage the bearing.
ST1 899874100 INSTALLER
ST2 399780104 WEIGHT
ST1
ST2
9) Apply seal material on the drive pinion shaft
thread and new self-locking nut seat.
SEAL MATERIAL
THREE BOND 1324 (Part No. 004403042) or
equivalent
Rear Differential (VA-type)
10) Attach the nut and use the ST to fix the com-
panion flange in place, then tighten.
ST 498427200
Tightening torque:
191 N·m (19.5 kgf-m, 141 ft-lb)
DI-00089
11) Check the initial torque and initial load.
Initial load:
12.7 — 32.2 N (1.3 — 3.3 kgf, 2.9 — 7.2 lb)
Initial torque:
0.48 — 1.22 N·m (0.049 — 0.124 kgf, 0.35 —
0.9 ft-lb)
DI-00090
DI-57
DIFFERENTIALS
FLANGE WRENCH
ST
DI-00161
DI-00152
DI-00481