Subaru LEGACY 2006 Manual page 3768

asieps_tobira.book 27 ページ ２００９年１０月２６日 月曜日 午前９時１６分
6) Connect the transmission to the engine.
(1) Install the starter.
<Ref. to SC(H4SO)-6, INSTALLATION, Start-
er.>
(2) Tighten the bolts which hold the upper side
of the transmission to the engine.
Tightening torque:
50 N·m (5.1 kgf-m, 36.9 ft-lb)
7) Remove the ST.
ST
8) Install the pitching stopper.
Tightening torque:
T1: 50 N·m (5.1 kgf-m, 37 ft-lb)
T2: 58 N·m (5.9 kgf-m, 43 ft-lb)
T2
9) Lift-up the vehicle.
10) Install the front drive shaft into the transmis-
sion.
Manual Transmission Assembly
11) Replace the differential side retainer oil seal.
<Ref. to 5MT-32, REPLACEMENT, Differential
Side Retainer Oil Seal.>
ST 18675AA000 DIFFERENTIAL SIDE OIL
NOTE:
Be sure to replace the differential side retainer oil
seal after the removing the front drive shaft.
MT-00073
12) Install the front drive shaft into the transmis-
sion.
ST 28399SA010 FRONT DRIVE SHAFT OIL
MT-01226
13) Install the ball joint of the lower arm.
Tightening torque:
49 N·m (5.0 kgf-m, 36 ft-lb)
T1
MT-00085
5MT-27
MANUAL TRANSMISSION AND DIFFERENTIAL
SEAL INSTALLER
ST
SEAL PROTECTOR
ST
(C)
(A)
(A) Front arm
(B) Ball joint
(C) Stabilizer link
MT-00103
AT-00110
(B)
MT-00987