Subaru LEGACY 2006 Manual page 3236

asieps_tobira.book 68 ページ ２００９年１０月２６日 月曜日 午前９時１６分
AUTOMATIC TRANSMISSION
25.Torque Converter Assembly
A: REMOVAL
1) Remove the transmission assembly from vehicle
body. <Ref. to 4AT-35, REMOVAL, Automatic
Transmission Assembly.>
2) Pull out the torque converter assembly and oil
pump shaft horizontally.
NOTE:
Be sure not to scratch the inside of bushing in oil
pump shaft.
3) Remove the input shaft.
NOTE:
When the torque converter assembly is removed,
the input shaft will also come off.
4) Remove the oil pump shaft from torque convert-
er assembly as necessary.
Torque Converter Assembly
B: INSTALLATION
1) When the oil pump shaft is removed, install the
shaft to converter case.
2) Install the oil pump shaft to the torque converter
assembly, and make sure the clip is secured on the
groove.
3) Apply ATF to the O-ring and insert on the input
shaft while rotating the shaft slowly by hand.
Normal protrusion A:
50 — 55 mm (1.97 — 2.17 in)
AT-00113
4) While holding the torque converter assembly by
hand, carefully install it to the converter case. Take
care not to damage the bushing. Do not allow the
oil pump shaft bushing to touch the starter shaft
part of the oil pump cover inappropriately.
5) Slowly rotate the shaft by hand to engage the
splines securely, then check that is within dimen-
sion A.
Dimension A:
2.7 — 2.9 mm (0.106 — 0.114 in)
AT-00114
6) Install the transmission assembly to the vehicle.
<Ref. to 4AT-38, INSTALLATION, Automatic
Transmission Assembly.>
C: INSPECTION
Make sure the ring gear and protrusion of the
torque converter assembly end are not deformed or
damaged.
4AT-68
A
(A)
(A) Dimension A
AT-00291
AT-00311