Subaru LEGACY 2006 Manual page 3961

asieps_tobira.book 28 ページ ２００９年１０月２６日 月曜日 午前９時１６分
DRIVE SHAFT SYSTEM
D: ASSEMBLY
NOTE:
Use specified grease.
BJ side:
NTG2218-M (Part No. 28395AG01A)
EBJ side
NTG2218-M (Part No. 28395AG01A)
DOJ side:
NKG205 (Part No. 28495AG00A)
1) Install the BJ or EBJ boot in specified position,
and fill it with 60 to 70 g (2.12 to 2.47 oz.) of speci-
fied grease.
2) Place the DOJ boot at the center of shaft.
CAUTION:
Be sure to wrap shaft splines with vinyl tape to
prevent boot from scratches.
3) Insert the DOJ cage onto shaft.
NOTE:
Insert the cage with the cutout portion facing the
shaft end, since the cage has an orientation.
(A)
(B)
(A) Cage
(B) Cutout portion
4) Install the DOJ inner race on shaft and fix the
snap ring in place with pliers.
NOTE:
Confirm that the snap ring is completely fitted in the
shaft groove.
Rear Drive Shaft
5) Install the cage to inner race fixed upon shaft.
NOTE:
Fit the cage with the protruding section aligned with
the track on the inner race, and turn by a half pitch.
(A) Inner race
(B) Cage
6) Fill 80 to 90 g (2.82 to 3.17 oz) of specified
grease into the inner side of the DOJ outer race.
7) Apply a thin coat of specified grease to the cage
pocket and six ball bearings.
8) Insert the six ball bearings into the cage pocket.
9) Align the outer race track and ball positions, and
place the shaft, inner race, cage and ball bearings
in the original positions, and then fix outer race in
place.
DS-00127
(A) Outer race
(B) Grease
DS-00128
DS-28
(B)
(A)
DS-00129
(A)
(B)
DS-00126