Subaru LEGACY 2006 Manual page 3702

asieps_tobira.book 23 ページ ２００９年１０月２６日 月曜日 午前９時１６分
4. Select Cable
A: REMOVAL
1) Set the vehicle on a lift.
2) Shift the select lever to "N" range.
3) Disconnect the ground cable from battery.
4) Lift up the vehicle.
5) Remove the front, center and rear exhaust pipes
and the muffler. (SOHC and DOHC non-turbo mod-
el)
• SOHC model
<Ref. to EX(H4SO)-4, REMOVAL, Front Exhaust
Pipe.> <Ref. to EX(H4SO)-7, REMOVAL, Center
Exhaust Pipe.> <Ref. to EX(H4SO)-8, REMOVAL,
Rear Exhaust Pipe.> <Ref. to EX(H4SO)-10, RE-
MOVAL, Muffler.>
• DOHC 3.0 L model
<Ref. to EX(H6DO)-4, REMOVAL, Front Exhaust
Pipe.> <Ref. to EX(H6DO)-7, REMOVAL, Rear Ex-
haust Pipe.> <Ref. to EX(H6DO)-9, REMOVAL,
Muffler.>
6) Remove the center and rear exhaust pipes and
the muffler. (DOHC turbo model)
<Ref. to EX(H4DOTC)-8, REMOVAL, Center Ex-
haust Pipe.> <Ref. to EX(H4DOTC)-12, REMOV-
AL, Rear Exhaust Pipe.> <Ref. to EX(H4DOTC)-
13, REMOVAL, Muffler.>
7) Remove the heat shield cover.
Select Cable
8) Remove the snap pin and washer from range se-
lect lever.
• 4AT
(D)
(A) Range select lever
(B) Snap pin
(C) Select cable
(D) Bracket
(E) Washer
• 5AT
(A) Range select lever
(B) Snap pin
(C) Select cable
(D) Bracket
(E) Washer
AT-01331
CS-23
CONTROL SYSTEMS
(A)
(B)
(C) (E)
CS-00036
(E)
(B)
(D)
(C)
CS-00327
(A)