Subaru LEGACY 2006 Manual page 3377

asieps_tobira.book 56 ページ ２００９年１０月２６日 月曜日 午前９時１６分
AUTOMATIC TRANSMISSION
19.Transmission Control Mod-
ule (TCM)
A: REMOVAL
1) Disconnect the ground cable from the battery.
2) Remove the lower cover and then disconnect
the connector.
3) Disconnect the connector from TCM.
(A)
(A) Transmission control module (TCM)
(B) Steering column
4) Remove the relay from TCM body.
5) Remove the TCM.
Transmission Control Module (TCM)
B: INSTALLATION
1) Install the relay to TCM body.
2) Install the TCM.
Tightening torque:
(B)
AT-02026
3) Connect the connector to TCM.
4) Install in the reverse order of removal.
5) Perform Clear Memory 2 operation. <Ref. to
5AT(diag)-18, CLEAR MEMORY MODE, OPERA-
TION, Subaru Select Monitor.>
6) Perform the inspection with driving the vehicle at
the end of repair work, and make sure there is no
faulty as below;
• Excessive shift shock
• Oil leakage from the transmission body, etc.
• Occurrence of noise caused by interference etc.
NOTE:
If excessive shift shock is felt, execute advance op-
eration of learning control. <Ref. to 5AT(diag)-22,
PROCEDURE, Learning Control.>
5AT-56
7.5 N·m (0.76 kgf-m, 5.5 ft-lb)
(A)
(A) Transmission control module (TCM)
(B) Steering column
(B)
AT-02026