Subaru LEGACY 2006 Manual page 3381

asieps_tobira.book 75 ページ ２００９年１０月２６日 月曜日 午前９時１６分
4) Remove the thrust washers, pinion gears and
washers from center differential assembly.
(A) Pinion gear
5) Pull out the intermediate shaft and thrust bear-
ing.
D: ASSEMBLY
1) Install the thrust washer onto intermediate shaft.
2) Install the thrust bearing onto intermediate shaft.
3) Install the pinion gears and washers.
4) Insert the shaft into the center differential as-
sembly.
5) Install the snap ring.
6) Using a press, install a new ball bearing into the
center differential assembly.
ST 498077000 REMOVER
(B)
(A) Plate
(B) Center differential carrier
7) Apply vaseline onto the seal ring outer surface
and shaft grooves.
8) Install a new seal ring.
E: INSPECTION
• Check each parts for holes, damages or other
foreign matters.
• Inspect the extension end play, and adjust it to
within the standard value. <Ref. to 5AT-67, AD-
JUSTMENT, Transfer Clutch.>
Center Differential Carrier
(A)
AT-00169
(A)
ST
AT-00170
5AT-75
AUTOMATIC TRANSMISSION