Subaru LEGACY 2006 Manual page 3380

asieps_tobira.book 74 ページ ２００９年１０月２６日 月曜日 午前９時１６分
AUTOMATIC TRANSMISSION
30.Center Differential Carrier
A: REMOVAL
1) Remove the transmission assembly from vehicle
body. <Ref. to 5AT-34, REMOVAL, Automatic
Transmission Assembly.>
2) Remove the rear wheel speed sensor, and sep-
arate the extension case from transmission case.
<Ref. to 5AT-65, REMOVAL, Extension Case.>
3) Extract the rear drive shaft. <Ref. to 5AT-70, RE-
MOVAL, Rear Drive Shaft.>
4) Pull out the center differential carrier assembly.
5) Pull out the shim(s) from transmission case.
B: INSTALLATION
1) Install the center differential assembly with the
shim(s).
NOTE:
Press-fit it to the bottom of bearing shoulder com-
pletely.
2) Insert the rear driveshaft assembly. <Ref. to
5AT-70, INSTALLATION, Rear Drive Shaft.>
3) Join the transmission case and the extension
case, and then install the rear vehicle speed sen-
sor. <Ref. to 5AT-65, REMOVAL, Extension
Case.>
4) Install the transmission assembly to the vehicle.
<Ref. to 5AT-37, INSTALLATION, Automatic
Transmission Assembly.>
Center Differential Carrier
C: DISASSEMBLY
1) Remove the seal ring.
(A) Seal ring
2) Using a press and ST, remove the ball bearing.
ST 498077600
AT-01972
3) Remove the snap ring, and pull out the shaft
from center differential assembly.
AT-01972
(A) Snap ring
(B) Shaft
5AT-74
(A)
AT-02015
REMOVER
AT-00167
(B)
(A)
AT-01973