Subaru LEGACY 2006 Manual page 3660

asieps_tobira.book 19 ページ ２００９年１０月２６日 月曜日 午前９時１６分
C: DISASSEMBLY
1) Remove the straight pin and reservoir tank.
(A)
(A) Reservoir tank
(B) Straight pin
2) Remove the oil seal.
(B)
(A) Oil seal
(B) Master cylinder
3) Move the cylinder boot towards the rear.
(B)
(A) Cylinder boot
(B) Master cylinder
4) Remove the snap ring.
CAUTION:
Be careful when removing the snap ring, to pre-
vent the rod, washer, piston and return spring
from flying out.
5) Remove the clutch damper.
Master Cylinder
(B)
CL-00046
(A)
CL-00047
(A)
CL-00048
CL-19
D: ASSEMBLY
1) Install the clutch damper.
Tightening torque:
46.6 N·m (4.75 kgf-m, 34.4 ft-lb)
2) Apply a coat of grease to the contact surfaces of
the push rod and piston before installation.
Grease:
SILICONE GREASE G40M (Part No.
004404003)
3) Assemble in the reverse order of disassembly.
Tightening torque:
10 N·m (1.0 kgf-m, 7 ft-lb)
E: INSPECTION
If any damage, deformation, wear, swelling, rust or
other faults are found on the cylinder, piston, push
rod, fluid reservoir, return spring, gasket, clutch
damper, cylinder boot or hose, replace the faulty
part.
(C)
(B)
(A)
(F)
(A) Master cylinder body
(B) Return spring
(C) Piston
(D) Stop ring
(E) Push rod ASSY
(F) Clutch damper
(G) Cylinder boot
CLUTCH SYSTEM
CL-00054
(G)
(D)
(E)
CL-00056