Subaru LEGACY 2006 Manual page 3733

asieps_tobira.book 68 ページ ２００９年１０月２６日 月曜日 午前９時１６分
MANUAL TRANSMISSION AND DIFFERENTIAL
2) Remove the oil seal.
NOTE:
Do not reuse the oil seal. Replace the oil seal with
a new part.
D: ASSEMBLY
1. DIFFERENTIAL CASE ASSEMBLY
1) Install the bevel gear and bevel pinion together
with washers, and insert the pinion shaft.
NOTE:
Face the chamfered side of washer toward gear.
(C)
(A) Bevel pinion
(B) Bevel gear
(C) Pinion shaft
2) Measure the backlash between the bevel gear
and pinion. If backlash is not within specified value,
install a suitable washer to adjust. <Ref. to 5MT-70,
ADJUSTMENT, Front Differential Assembly.>
NOTE:
Be sure the pinion gear teeth contacts adjacent
gear teeth during measurement.
ST1 498247001 MAGNET BASE
ST2 498247100 DIAL GAUGE
Front Differential Assembly
Standard backlash
0.13 — 0.18 mm (0.0051 — 0.0071 in)
3) Align the pinion shaft and differential case with
each hole, and drive the straight pin into the holes
MT-01003
from the hypoid driven gear using the ST.
NOTE:
Lock the straight pin after installing.
ST 899904100
(B)
(A)
MT-00284
4) Install the roller bearing to differential case.
NOTE:
• Do not apply pressure in excess of 10 kN (1 ton,
1.1 US ton, 1.0 Imp ton).
• Be careful because the roller bearing outer races
are used as a set.
ST1 499277100
ST2 398497701
5MT-68
ST2
ST1
REMOVER
(A)
(C)
(B)
(A) Pinion shaft
(B) Differential case
(C) Straight pin
BUSHING 1-2 INSTALLER
ADAPTER
ST1
ST2
MT-00285
MT-00286
MT-00287