Subaru LEGACY 2006 Manual page 3771

asieps_tobira.book 75 ページ ２００９年１０月２６日 月曜日 午前９時１６分
19.Shifter Fork and Rod
A: REMOVAL
1) Remove the manual transmission assembly
from the vehicle. <Ref. to 5MT-24, REMOVAL,
Manual Transmission Assembly.>
2) Remove the back-up light switch and the neutral
position switch. <Ref. to 5MT-33, REMOVAL,
Switches and Harness.>
3) Remove the transfer case together with the ex-
tension case assembly. <Ref. to 5MT-36, REMOV-
AL, Transfer Case
Assembly.>
4) Remove the transmission case. <Ref. to 5MT-
48, REMOVAL, Transmission Case.>
5) Remove the drive pinion shaft assembly. <Ref.
to 5MT-57, REMOVAL, Drive Pinion Shaft Assem-
bly.>
6) Remove the main shaft assembly.
<Ref. to 5MT-51, REMOVAL, Main Shaft Assembly
for Single-range.>
7) Remove the differential assembly. <Ref. to 5MT-
66, REMOVAL, Front Differential Assembly.>
8) Drive out the straight pin by tapping with the ST,
and pull out the 5th shifter fork.
ST 398791700 STRAIGHT PIN REMOVER
( B )
( A )
(A) Straight pin
(B) 5th shifter fork
9) Remove the plugs, springs and check balls.
Shifter Fork and Rod
and Extension Case
MT-00309
5MT-75
MANUAL TRANSMISSION AND DIFFERENTIAL
10) Drive out the straight pin tapping by the ST, and
pull out the 3-4 fork rod and shifter fork.
NOTE:
When removing the rod, keep other rods in neutral.
Also, when pulling out the straight pin, remove it to-
ward the inside of case so that it does not hit
against the case.
ST 398791700 STRAIGHT PIN REMOVER
(C)
(A) (B)
(A) Straight pin
(B) 3-4 fork rod
(C) Shifter fork
11) Drive out the straight pin by tapping with the
ST, and pull out the 1-2 fork rod and shifter fork.
ST 398791700 STRAIGHT PIN REMOVER
12) Remove the outer snap ring, and pull out the
reverse shifter rod arm and reverse fork rod. Then
take out the ball, spring and interlock plunger from
the rod.
And then remove the rod.
NOTE:
When pulling out the reverse shifter rod arm, be
careful not to let the ball pop out of arm.
13) Remove the reverse shifter lever.
B: INSTALLATION
1) Install the reverse arm fork spring, ball and inter-
lock plunger to the reverse fork rod arm. Insert the
reverse fork rod into the hole of the reverse fork rod
arm, and hold it with the outer snap ring using ST.
NOTE:
Apply grease to plunger to prevent it from falling.
ST 399411700 ACCENT BALL INSTALLER
2) Position the ball, spring and new gasket in the
reverse shifter rod hole on the left side of transmis-
sion case, and tighten the checking ball plug.
3) Install the 1st-2nd fork rod into 1st-2nd shifter
fork through the hole on the rear of transmission
case.
MT-00994