Subaru LEGACY 2006 Manual page 3951

asieps_tobira.book 11 ページ ２００９年１０月２６日 月曜日 午前９時１６分
13) Install an extension cap to the transmission.
NOTE:
If extension cap is not available, place vinyl bag
over opening and fasten with string to prevent gear
oil or ATF from leaking.
(A)
(A) Extension cap
Propeller Shaft
B: INSTALLATION
1) Insert the sleeve yoke into the transmission and
attach center bearing to body.
Tightening torque:
52 N·m (5.3 kgf-m, 38.3 ft-lb)
DS-00031
2) Align the alignment marks and connect the
flange yoke and rear differential.
Tightening torque:
31 N·m (3.2 kgf-m, 23.1 ft-lb)
(A) Alignment mark
3) Install the heat shield cover.
4) Install the center exhaust pipe.
5) Install the rear exhaust pipe and muffler.
6) Lower the vehicle.
7) Connect the ground cable to battery.
DS-11
DRIVE SHAFT SYSTEM
DS-00141
(A)
DS-00028