Subaru LEGACY 2006 Manual page 3806

asieps_tobira.book 10 ページ ２００９年１０月２６日 月曜日 午前９時１６分
ABS
3. ABS Sequence Control
A: OPERATION
1) While the ABS sequence control is being per-
formed, the operation of the hydraulic unit can be
checked using the brake tester or pressure gauge
after the hydraulic unit solenoid valve operation.
2) ABS sequence control can be started by the
Subaru Select Monitor.
1. ABS SEQUENCE CONTROL WITH SUB-
ARU SELECT MONITOR
NOTE:
In the event of any trouble, the ABS sequence con-
trol will not operate.
1) Connect the Subaru Select Monitor to data link
connector under the driver's side instrument panel
lower cover.
2) Turn the ignition switch to ON.
3) Set the Subaru Select Monitor switch to ON.
4) Set the Subaru Select Monitor to "Brake Control"
mode.
5) When the "Function check sequence" is select-
ed, the "ABS sequence control" will start.
6) Execute the following operations when the mes-
sage "Press the brake pedal so that the brake ped-
al force is between 100 and 150 kgf" is displayed.
(1) When the brake tester is used, press brake
pedal pad with a force of 1,000 N (102 kgf, 225
lb).
(2) When using a pressure gauge, depress the
brake pedal so that the pressure gauge indi-
cates 3,500 kPa (36 kg/cm
7) "Press the "YES" key" will be displayed. Press
the [YES] key.
8) The brake system being operated is displayed
on the Subaru Select Monitor.
ABS Sequence Control
2
, 511 psi).
ABS-10