Subaru LEGACY 2006 Manual page 3281

asieps_tobira.book 37 ページ ２００９年１０月２６日 月曜日 午前９時１６分
28) Remove the bolt securing the ball joint of the
front arm to housing.
29) Pull out the front drive shaft from the transmis-
sion.
(1) Using a tire lever or a crow bar, etc., pull out
until the front drive shaft transmission side joint
slides move smoothly.
NOTE:
Place cloth between the tire lever or bar and the
transmission in order to avoid damaging the trans-
mission side retainer.
(2) Hold the transmission side joint of the front
drive shaft by hand and extract the housing
from the transmission while pressing the hous-
ing outward, so as not to stretch the boot.
30) Remove the bolts which hold the clutch hous-
ing cover.
31) Remove the bolts which hold the lower side of
transmission to the engine.
32) Place the transmission jack under the transmis-
sion.
NOTE:
Make sure that the support plates of transmission
jack do not touch the oil pan.
Automatic Transmission Assembly
33) Remove the transmission rear crossmember
from the vehicle.
AT-00809
34) While lowering the transmission jack gradually,
fully retract the engine support, and then tilt the en-
gine rearward.
NOTE:
Retract the support until the clearance between
front crossmember and converter case becomes
approx. 10 mm (0.39 in).
35) Remove the transmission.
CAUTION:
Remove the transmission and torque converter
as a single unit from engine.
36) Remove the rear cushion rubber from the
transmission assembly.
AT-00108
4AT-37
AUTOMATIC TRANSMISSION
AT-01334
AT-00109