Subaru LEGACY 2006 Manual page 3341

asieps_tobira.book 76 ページ ２００９年１０月２６日 月曜日 午前９時１６分
AUTOMATIC TRANSMISSION
31.Parking Pawl
A: REMOVAL
1) Remove the transmission assembly from vehicle
body. <Ref. to 5AT-34, REMOVAL, Automatic
Transmission Assembly.>
2) Remove the extension case. <Ref. to 5AT-65,
REMOVAL, Extension Case.>
3) Remove the center differential carrier. <Ref. to
5AT-74, REMOVAL, Center Differential Carrier.>
4) Remove the front vehicle speed sensor. <Ref. to
5AT-47, REMOVAL, Front Vehicle Speed Sensor.>
5) Remove the parking support actuator.
6) Remove the parking pawl, parking pawl shaft
and return spring.
B: INSTALLATION
1) Set the transmission to the N range.
2) Install the parking pawl, parking pawl shaft and
return spring.
Parking Pawl
3) Install the parking support actuator.
Tightening torque:
±
10 2 N·m (1.0
4) Using the ST, tighten the bolts which tightened in
step 3) with specified angle.
Tightening angle:
±
17° 2°
ST 18854AA000 ANGLE GAUGE
NOTE:
Do not use extension as much as possible.
AT-03236
AT-03272
AT-03272
5AT-76
± ±
0.2 kgf-m, 7.4 1.5 ft-lb)
AT-03236
ST
AT-02071
ST
AT-02072