Subaru LEGACY 2006 Manual page 3712

asieps_tobira.book 39 ページ ２００９年１０月２６日 月曜日 午前９時１６分
4) Install the snap ring to gear shift lever and install
the bushing.
NOTE:
Apply grease to the bushing.
(A) Spring pin
(B) Bushing
5) Apply grease to the bushing and O-ring, and
then install to gear shift lever.
(A) (B) (A)
(A) O-ring
(B) Bushing
(C) Snap ring
6) Apply sufficient grease into boss, and then install
the gear shift lever to the stay.
MT Gear Shift Lever
(B)
(A)
CS-00060
(C)
CS-00320
CS-00319
CS-39
7) Install the washer and snap ring.
(A)
(A) Snap ring
8) Insert the gear shift lever and rod into boot hole.
9) Install the rod.
Tightening torque:
12 N·m (1.2 kgf-m, 8.9 ft-lb)
(A)
(C)
(A) Rod
(B) Lever
(C) Stay
CONTROL SYSTEMS
CS-00318
(B)
CS-00317