Subaru LEGACY 2006 Manual page 3239

asieps_tobira.book 96 ページ ２００９年１０月２６日 月曜日 午前９時１６分
AUTOMATIC TRANSMISSION
6) Install new seal pipe to converter case.
(A) Seal pipe
7) Install the converter case to the transmission
case. <Ref. to 4AT-81, INSTALLATION, Converter
Case.>
8) Insert the inhibitor switch and transmission con-
nector to the stay.
(B)
(A) Transmission connector
(B) Inhibitor switch connector
9) Install the oil cooler pipe. <Ref. to 4AT-64, IN-
STALLATION, ATF Cooler Pipe and Hose.>
10) Install the oil charge pipe together with an O-
ring. <Ref. to 4AT-67, INSTALLATION, Oil Charge
Pipe.>
11) Insert the input shaft while rotating it lightly by
hand, and then check the amount of protrusion.
Normal protrusion A:
50 — 55 mm (1.97 — 2.17 in)
A
12) Install the torque converter assembly. <Ref. to
4AT-68, INSTALLATION, Torque Converter As-
sembly.>
Front Differential Assembly
13) Install the transmission assembly to the vehi-
cle. <Ref. to 4AT-38, INSTALLATION, Automatic
Transmission Assembly.>
C: DISASSEMBLY
1. DIFFERENTIAL CASE ASSEMBLY
1) Remove the taper roller bearing using the ST
and a press.
ST 498077000
AT-00176
(A)
2) Secure the case in a vise, remove the hypoid
driven gear tightening bolts, and then separate the
hypoid driven gear into case (RH) and case (LH).
AT-01351
3) Pull out the straight pin and shaft, and then re-
move the differential bevel gear, washer and differ-
ential bevel pinion.
AT-00291
4AT-96
REMOVER
(C)
(A) Hypoid driven gear
(B) Differential case (RH)
(C) Differential case (LH)
(A)
(A) Differential case (RH)
AT-00216
(A)
(B)
AT-00217
AT-00218