Subaru LEGACY 2006 Manual page 3681

asieps_tobira.book 16 ページ ２００９年１０月２６日 月曜日 午前９時１６分
CLUTCH SYSTEM
5. Operating Cylinder
A: REMOVAL
1) Remove the air intake chamber. <Ref. to
IN(H4SO)-7, REMOVAL, Air Intake Chamber.>
2) Disconnect the clutch hose from the operating
cylinder.
CAUTION:
Cover the hose joint to prevent the clutch fluid
from flowing out.
(A)
(B)
(A) Clutch hose
(B) Operating cylinder
3) Remove the operating cylinder from the trans-
mission.
Operating Cylinder
B: INSTALLATION
1) Install in the reverse order of removal.
NOTE:
Before installing the operating cylinder, apply
grease (KOPR-KOTE: Part No. 003603001) to the
contact point of the release lever and operating cyl-
inder.
Tightening torque:
T1: 18 N·m (1.8 kgf-m, 13.0 ft-lb)
T2: 37 N·m (3.8 kgf-m, 27.5 ft-lb)
T1
CL-00367
2) After bleeding air from the operating cylinder,
ensure that the clutch operates properly.
<Ref. to CL-22, Clutch Fluid Air Bleeding.>
C: DISASSEMBLY
1) Remove the boot and push rod.
MT-01220
2) Blow compressed air through the clutch hose at-
tachment hole.
NOTE:
To prevent the piston from popping out, point the
piston hole downward, and position a piece of
wood in the way.
CL-16
T2
T2
CL-00368
CL-00457
CL-00458