Subaru LEGACY 2006 Manual page 4010

asieps_tobira.book 42 ページ ２００９年１０月２６日 月曜日 午前９時１６分
POWER ASSISTED SYSTEM (POWER STEERING)
4) Connect the suction hose and pressure hose to
the oil pump. Tighten the eye bolt of pressure hose.
Tightening torque:
40 N·m (4.1 kgf-m, 29.5 ft-lb)
(2)
(1) Suction hose
(2) Pressure hose
5) Temporarily connect pressure hose and pipe C,
and the return hose and pipe D. Place clamp E in
the position shown in the figure, and tighten the bolt
temporarily.
(3)
(4)
(1) Return hose
(2) Pressure hose
(3) Approx. 18 mm (0.71 in)
(4) Clamp E
(5) Pipe C
(6) Pipe D
6) Tighten clamp E.
Tightening torque:
7.4 N·m (0.75 kgf-m, 5.4 ft-lb)
Pipe Assembly
(1)
PS-00460
(1)
(2)
(6)
(5)
PS-00539
PS-42
7) Tighten the pressure hose and pipe C, and the
return hose and pipe D.
Tightening torque:
15 N·m (1.5 kgf-m, 10.8 ft-lb)
8) Connect pipes A and B to the four pipe joints of
the gearbox.
Tightening torque:
Refer to "COMPONENT" of "General Descrip-
tion". <Ref. to PS-4, POWER ASSISTED SYS-
TEM, COMPONENT, General Description.>
(2)
(1) Pipe A
(2) Pipe B
9) Install the front crossmember support plate and
jack-up plate.
10) Lower the vehicle.
11) Tighten the bolts which hold the hose bracket.
Tightening torque:
10 N·m (1.02 kgf-m, 7.4 ft-lb)
(1) Hose ASSY
(2) Hose bracket
12) Install the air intake
IN(H4DOTC)-9, INSTALLATION, Air Intake Duct.>
<Ref. to IN(H4SO)-8, INSTALLATION, Air Intake
Duct.>
13) Connect the ground cable to battery.
14) Fill with the specified fluid.
CAUTION:
Never start the engine before filling with fluid;
otherwise the vane pump may become seized.
(1)
PS-00553
(2)
(1)
PS-00624
duct. <Ref. to