Subaru LEGACY 2006 Manual page 3325

asieps_tobira.book 80 ページ ２００９年１０月２６日 月曜日 午前９時１６分
AUTOMATIC TRANSMISSION
33.Oil Pump Cover
A: REMOVAL
1) Remove the transmission assembly from vehicle
body. <Ref. to 5AT-34, REMOVAL, Automatic
Transmission Assembly.>
2) Pull out the torque converter assembly. <Ref. to
5AT-63, REMOVAL, Torque Converter Assembly.>
3) Remove the transmission harness connector
from stay.
4) Remove the oil charge pipe. <Ref. to 5AT-62,
REMOVAL, Oil Charge Pipe.>
5) Remove the ATF filter inlet and outlet pipes.
<Ref. to 5AT-55, REMOVAL, ATF Filter.>
6) Separate the converter case and transmission
case. <Ref. to 5AT-78, REMOVAL, Converter
Case.>
7) Remove the oil pump cover mounting bolt, and
then separate the oil pump cover from the AT main
case by lightly tapping with plastic hammer.
B: INSTALLATION
1) Secure the oil pump cover.
Tightening torque:
41 N·m (4.2 kgf-m, 30.4 ft-lb)
2) Install the converter case assembly to the trans-
mission case assembly. <Ref. to 5AT-63, INSTAL-
LATION, Torque Converter Assembly.>
3) Install the transmission harness connector to the
stay.
4) Install the ATF filter pipe. <Ref. to 5AT-55, IN-
STALLATION, ATF Filter.>
Oil Pump Cover
5) Install the oil charge pipe together with an O-
ring. <Ref. to 5AT-62, INSTALLATION, Oil Charge
Pipe.>
6) Install the torque converter assembly. <Ref. to
5AT-63, INSTALLATION, Torque Converter As-
sembly.>
7) Install the transmission assembly to the vehicle.
<Ref. to 5AT-37, INSTALLATION, Automatic
Transmission Assembly.>
C: DISASSEMBLY
1. FRONT BRAKE
1) Remove the snap ring.
2) Remove the retainer plate, drive plate and driven
plate.
3) Using the ST1, ST2 and ST3, remove the snap
ring.
ST1 18762AA000 COMPRESSOR SPECIAL
AT-01976
ST2 18765AA000 COMPRESSOR SUPPORT
ST3 18763AA000 COMPRESSOR SHAFT
ST2
4) Remove the retainer and return spring.
AT-01976
5AT-80
AT-01980
TOOL
ST1
ST3
AT-01981