Subaru LEGACY 2006 Manual page 3634

asieps_tobira.book 5 ページ ２００９年１０月２６日 月曜日 午前９時１６分
3. General Description
A: CAUTION
• Supplemental Restraint System "Airbag"
The airbag system wiring harness is routed near
the TCM.
CAUTION:
• All the airbag system wiring harnesses and
connectors are colored yellow. Do not use an
electric test equipment to check these circuits.
• Be careful not to damage the airbag system
wiring harness when performing diagnostics or
servicing the TCM.
• Measurement
When measuring the voltage and resistance of the
ECM, TCM or each sensor, use a tapered pin with
a diameter of less than 0.64 mm (0.025 in) in order
to avoid poor contact. Do not insert a pin of more
than 0.65 mm (0.026 in) diameter.
B: INSPECTION
1. BATTERY
Measure the battery voltage and specific gravity of
the electrolyte.
Standard voltage: 12 V or more
Specific gravity: 1.260 or more
2. TRANSMISSION GROUND
Make sure that the ground terminal bolt is tightened
securely.
Tightening torque:
13 N·m (1.3 kgf-m, 9.4 ft-lb)
General Description
AUTOMATIC TRANSMISSION (DIAGNOSTICS)
3. ATF LEVEL
Make sure that ATF level is the specified amount.
<Ref. to 5AT-26, INSPECTION, Automatic Trans-
mission Fluid.>
(A) Level gauge
(B) Inspection position when "HOT"
(C) Upper level
(D) Lower level
(E) Inspection position when "COLD"
4. FRONT DIFFERENTIAL OIL LEVEL
Make sure the front differential oil level is the spec-
ified amount. <Ref. to 5AT-28, INSPECTION, Dif-
ferential Gear Oil.>
(A) Upper level
(B) Lower level
AT-01464
5AT(diag)-5
(A)
(C)
(D)
(E)
AT-03276
(A)
(B)
AT-00317
(B)
(C)
(D)