Subaru LEGACY 2006 Manual page 3376

asieps_tobira.book 28 ページ ２００９年１０月２６日 月曜日 午前９時１６分
AUTOMATIC TRANSMISSION
3. Differential Gear Oil
A: INSPECTION
1) Park the vehicle on a level surface.
2) Remove the collector cover.
3) Remove the oil level gauge and wipe it clean.
4) Reinsert the level gauge all the way. Make sure
the level gauge is inserted correctly and in the
proper orientation.
5) Remove the oil level gauge again, and check the
level of differential gear oil. If the differential gear oil
level is below "L" line, add oil to bring the level up to
"F" line.
NOTE:
To prevent overfilling the differential gear oil, do not
add oil above the "F" line.
(A) Upper level
(B) Lower level
Differential Gear Oil
B: REPLACEMENT
1) Lift-up the vehicle.
2) Remove the differential gear oil drain plug using
®
TORX BIT T70, and then drain differential gear
oil.
CAUTION:
• Immediately after the vehicle has been run-
ning or after idling for a long time, the differen-
tial gear oil will be hot. Be careful not to burn
yourself.
• Be careful not to spill differential gear oil on
the exhaust pipe to prevent it from emitting
smoke or causing a fire. If differential gear oil is
spilled on the exhaust pipe, wipe it off com-
pletely.
3) Tighten the differential gear oil drain plug using
®
TORX BIT T70.
NOTE:
Use a new gasket.
Tightening torque:
70 N·m (7.1 kgf-m, 51.6 ft-lb)
( A )
( B )
AT-00017
(A) Oil pan
(B) Differential gear oil drain plug
4) Lower the vehicle.
5) Pour gear oil into the gauge hole.
Recommended gear oil:
<Ref. to 5AT-3, RECOMMENDED GEAR OIL,
SPECIFICATION, General Description.>
Gear oil capacity:
1.3 — 1.5
6) Check the level of differential gear oil.
<Ref. to 5AT-28, INSPECTION, Differential Gear
Oil.>
5AT-28
(A)
(B)
AT-03127
(1.4 — 1.6 US qt, 1.1 — 1.3 Imp qt)
2