Subaru LEGACY 2006 Manual page 4035

bp06usen601.fm 31 ページ ２０１０年５月２７日 木曜日 午後３時６分
39) If the tie-rod end has been removed, screw in
lock nut and tie-rod end to the screwed portion of
tie-rod, and tighten the lock nut temporarily in a po-
sition as shown in the figure.
Installed tie-rod length L:
31 mm (1.22 in)
40) Inspect the gearbox as follows:
"A" Holding the tie-rod end, repeat movement from
lock to lock two or three times as quickly as possi-
ble.
"B" Holding the tie-rod end, turn a few times as
slowly as possible.
Finally, make sure that the boot is installed in the
specified position without inflating.
41) Remove the gearbox from ST.
ST1 926200000 STAND
ST2 34199AG000 BOSS D
Steering Gearbox
L
PS-00097
A
B
PS-00098
PS-31
POWER ASSISTED SYSTEM (POWER STEERING)
42) Install the four pipes on gearbox.
(1) Connect the pipes A and B to the four pipe
joints of gearbox.
Tightening torque:
Refer to the component parts. <Ref. to PS-4,
POWER ASSISTED SYSTEM, COMPONENT,
General Description.>
(2) Connect the pipes C and D to gearbox.
Tightening torque:
Pipe C: 37 N·m (3.8 kgf-m, 27.3 ft-lb)
Pipe D: 29 N·m (3.0 kgf-m, 21.4 ft-lb)
(2)
(1)
(1) Pipe C
(2) Pipe D
2. CONTROL VALVE ASSEMBLY
Specified steering grease:
VALIANT GREASE M2 (Part No. 003608001)
1) Clean all parts and tools before reassembling.
2) Apply a coat of specified power steering fluid to
the inner wall of valve housing.
(1)
(1) Apply fluid.
3) Apply a coat of grease to the oil seal.
4) Verify the direction of oil seal.
PS-00525
PS-00169