Subaru LEGACY 2006 Manual page 4031

bp06usen601.fm 27 ページ ２０１０年５月２７日 木曜日 午後３時６分
9) Apply a coat of grease to the grooves in rack,
sliding surface of sleeve and sealing surface of pis-
ton. Then insert the rack into steering body from
cylinder side.
10) Temporarily tighten the new holder to gearbox
cylinder.
11) Put a mark at the specified position from the
end surface of the ST as shown in the figure.
Specified position:
Except for 2.5 GT-B:
13.5 mm (0.53 in)
2.5 GT-B:
18.9 mm (0.74 in)
ST 34199FE000 INSTALLER & REMOVER
(2)
(1) 13.5 mm (0.53 in) or 18.9 mm (0.74 in)
(2) Put a mark.
12) Attach the ST to the rack end surface.
ST 34199FE000 INSTALLER & REMOVER
13) Using a press, press-fit until the mark on the ST
is aligned to the end surface of the holder.
(2)
(1) Marked position
(2) Holder
14) Remove the ST and the holder.
15) Insert the outer side oil seal to the rack in the
same procedure as in step 5) and 6).
ST 926390001 COVER & REMOVER
Steering Gearbox
POWER ASSISTED SYSTEM (POWER STEERING)
16) Put the ST and pipe through the rack and
press-fit the outer side oil seal using a press.
ST 34199AG010 INSTALLER
17) Secure the gearbox in a vise using ST.
ST1 926200000
ST2 34199AG000 BOSS D
PS-00851
18) Tighten the new holder.
Tightening torque:
ST
70 N·m (7.1 kgf-m, 51.6 ft-lb)
(1)
PS-00522
PS-27
(1) Pipe
(2) Outer side oil seal
STAND
(1)
ST2
(1) Clamp
PS-00852
ST1
PS-00492