Subaru LEGACY 2006 Manual page 4176

asieps_tobira.book 23 ページ ２００９年１０月２６日 月曜日 午前９時１６分
Step
11 CHECK THE HARNESS CONNECTOR BE-
TWEEN VDCCM&H/U AND CHASSIS
GROUND.
1) Turn the ignition switch to OFF.
2) Disconnect the connector from the
VDCCM&H/U.
3) Measure the resistance of harness
between VDCCM&H/U connector and chassis
ground.
Connector & terminal
(B310) No. 6 — Chassis ground:
12 CHECK POOR CONTACT IN CONNECTOR. Is there poor contact in control
Subaru Select Monitor
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS)
Check
Is the resistance less than 0.5
Ω?
module power supply, ground
circuit and data link connector?
VDC(diag)-23
Yes No
Go to step 12. Repair the open
circuit in harness
between
VDCCM&H/U and
inhibitor side con-
nector, and poor
contact of coupling
connector.
Repair the con- Replace the
nector. VDCCM&H/U.
<Ref. to VDC-7,
VDC Control Mod-
ule and Hydraulic
Control Unit
(VDCCM&H/U).>