Subaru LEGACY 2006 Manual page 3652

asieps_tobira.book 11 ページ ２００９年１０月２６日 月曜日 午前９時１６分
4) Install the transmission assembly. <Ref. to 5MT-
26, INSTALLATION, Manual Transmission Assem-
bly.>
C: INSPECTION
NOTE:
The illustration below is for a Non-turbo model.
However, perform the same procedures for the
Turbo model.
1. CLUTCH DISC
1) Facing wear:
Measure the depth from the facing surface to the
rivet head. Replace if the face is worn locally or
worn down to less than the specified value.
Depth to rivet head:
Limit of sinking
0.3 mm (0.012 in)
NOTE:
Do not wash the clutch disc with any type of clean-
ing fluid.
2) Hardened facing
Replace the clutch disc.
3) Oil soakage on facing
Replace the clutch disc and inspect the transmis-
sion front oil seal, transmission case mating sur-
face, engine rear oil seal and other locations for oil
leakage.
(A) Clutch facing
Clutch Disc and Cover
4) Deflection on facing:
If deflection exceeds the specified value at the out-
er circumference of the facing, replace the clutch
disc.
ST 499747100
Limit for deflection:
Turbo model
1.0 mm (0.039 in) at R = 110 mm (4.33 in)
Non-turbo model
0.7 mm (0.027 in) at R = 110 mm (4.33 in)
5) If there is spline wear, loose rivets, failed damper
springs, etc., replace the clutch disc.
CL-00014
(A) Spline
(B) Rivet
(C) Damper spring
(A)
CL-00015
CL-11
CLUTCH SYSTEM
CLUTCH DISC GUIDE
S T
CL-00016
CL-00017