Subaru LEGACY 2006 Manual page 3363

Hide thumbs Also See for LEGACY 2006:

asieps_tobira.book 93 ページ２００９年１０月２６日　月曜日　午前９時１６分

6) Tighten the LH retainer by rotating the shaft until

resistance is felt. Then loosen the retainer RH.

Keep tightening the retainer LH, and loosening the

retainer RH until the pinion shaft no longer be

turned. This is the "zero" state.

(A) Retainer

7) After the "zero" state is established, back off the

retainer LH 3 notches and secure it with the lock

plate. Then back off the retainer RH and retighten

until it stops. Rotate the drive pinion 2 or 3 times.

Tighten the retainer RH further 1-3/4 notches. This

sets the preload. Finally, secure the retainer with its

(A) Lock plate

Turning the retainer by one tooth changes the

backlash approx. 0.05 mm (0.0020 in).

(A) 0.05 mm (0.0020 in)

Front Differential Assembly

8) Turn the drive pinion several times using ST1,

and check to see if the backlash is within the spec-

ification using ST2, ST3, ST4 and ST5.

ST1 499787700

ST2 498247001

ST3 498247100

ST4 499787500

ST5 498255400

9) Adjust the teeth contact of the front differential

and drive shaft. <Ref. to 5AT-87, ADJUSTMENT,

Drive Pinion Shaft Assembly.>

AUTOMATIC TRANSMISSION

0.13 — 0.18 mm (0.0051 — 0.0071 in)

Show Quick Links

Chapters