Subaru LEGACY 2006 Manual page 3979

asieps_tobira.book 11 ページ ２００９年１０月２６日 月曜日 午前９時１６分
6. REAR WHEEL TOE-IN
• INSPECTION
Toe-in:
OUTBACK model
–3 — 0 mm (–0.12 — 0 in)
Except for OUTBACK model
± ±
0 3 mm (0 0.12 in)
Refer to FRONT WHEEL TOE-IN for rear toe-in in-
spection procedures.
<Ref. to FS-10, FRONT WHEEL TOE-IN, INSPEC-
TION, Wheel Alignment.>
• ADJUSTMENT
When adjusting, adjust it to the following value.
Toe-in:
OUTBACK model
–3 — 0 mm (–0.12 — 0 in)
Except for OUTBACK model
± ±
0 2 mm (0 0.08 in)
1) Loosen the self-locking nut on the inner side of
rear link.
Rotate the left side clockwise.
Rotate the left side counterclockwise.
Wheel Alignment
NOTE:
When loosening or tightening the adjusting bolt,
hold the bolt head and turn the self-locking nut.
(1) Adjusting bolt
(2) Rear link
2) Turn the adjusting bolt until toe-in is within the
specification.
NOTE:
When the left and right wheels are adjusted for toe-
in at the same time, the movement of one scale
graduation changes toe-in by approx. 0.6 mm (0.02
in).
To increase toe-in.
Rotate the right side counterclockwise.
FS-00018
To decrease toe-in.
Rotate the right side clockwise.
FS-00019
FS-11
FRONT SUSPENSION
(1)
(2)
FS-00103
FS-00019
FS-00018