Subaru LEGACY 2006 Manual page 3373

asieps_tobira.book 103 ページ ２００９年１０月２６日 月曜日 午前９時１６分
F: ADJUSTMENT
1) Using the ST, measure the height "A" from the
AT main case mating surface to convex surface of
oil pump cover.
ST 499575400 GAUGE
2) Using the ST, measure the depth "B" from the
convex surface of oil pump cover to thrust bearing
transferring surface.
ST 499575400 GAUGE
B
3) Calculate the measured value from step 1) and
2), and then set the calculated value as "C"
Calculation formula: C = A – B
4) Using the ST, measure the depth "D" from the
AT main case mating surface to thrust bearing
transferring surface of front sun gear.
ST 499575400 GAUGE
ST
AT Main Case
ST
A
AT-02012
ST
AT-02013
D
AT-02014
5AT-103
AUTOMATIC TRANSMISSION
5) Set the value as "E" which subtract the thickness
of ST (GAUGE) from the measured value on step
4).
Calculation formula: E (mm) = D – 15
[E (in) = D – 0.59]
6) Calculation formula:
Select one thrust bearing from the table to adjust
clearance within 0.25 — 0.55 mm (0.0098 — 0.022
in).
When clearances are 0.25 mm (0.0098 in):
T (mm) = E – C + 0.03
[T (in) = E – C + 0.0012]
When clearances are 0.55 mm (0.022 in):
T (mm) = E – C + 0.27
[T (in) = E – C + 0.012]
T: Thrust bearing clearance
C: Distance from oil pump cover mating surface to
rear end of oil pump cover
E: Depth from mating surface of AT main case to
bearing surface of front sun gear
NOTE:
Calculation formula for "T" above is applied when
measuring with the ST (499575400 GAUGE). In
the calculation without using ST, substitute the
thickness of collar used to calculate the value "E"
on step 5).
Thrust bearing
Part number
806548020
606548030
806548040
806548050
806548060
806548070
Thickness mm (in)
3.2 (0.126)
3.4 (0.134)
3.6 (0.142)
3.8 (0.150)
4.0 (0.157)
4.2 (0.165)