Subaru LEGACY 2006 Manual page 3960

asieps_tobira.book 27 ページ ２００９年１０月２６日 月曜日 午前９時１６分
6) Lock the axle nut securely.
7) Install the wheel.
Tightening torque:
110 N·m (11.2 kgf-m, 81.1 ft-lb)
C: DISASSEMBLY
1) Straighten the bent claw at the larger end of the
DOJ boot.
2) Loosen the band by means of screwdriver or pli-
ers.
CAUTION:
Be careful not to damage the boot.
3) Remove the boot band on the small end of DOJ
boot in the same manner.
4) Remove the larger end of DOJ boot from DOJ
outer race.
5) Pry and remove the round circlip at the neck of
DOJ outer race with a screwdriver.
6) Take out the DOJ outer race from the shaft as-
sembly.
Rear Drive Shaft
7) Wipe off the grease and take out the ball bear-
ings.
CAUTION:
The grease is a special grease (grease for con-
stant velocity joints). Do not mix with other
greases.
NOTE:
Disassemble exercising care not to lose balls (6
pcs).
DS-00048
(A) Outer race
(B) Grease
8) To remove the cage from inner race, turn the
cage by a half pitch to the track groove of inner race
and shift the cage.
9) Using pliers, remove the snap ring fixing the in-
ner race to the shaft.
10) Take out the DOJ inner race.
11) Take off the DOJ cage from shaft and remove
the DOJ boot.
CAUTION:
DS-00124
Be sure to wrap shaft splines with vinyl tape to
prevent boot from scratches.
12) Remove the BJ boot or EBJ boot in the same
procedure as the DOJ boot.
NOTE:
Further disassembly of axle is impossible because
the BJ and EBJ cannot be disassembled.
DS-00125
DS-27
DRIVE SHAFT SYSTEM
(A)
(B)
DS-00126