Subaru LEGACY 2006 Manual page 3521

asieps_tobira.book 18 ページ ２００９年１０月２６日 月曜日 午前９時１６分
AUTOMATIC TRANSMISSION (DIAGNOSTICS)
Input clutch oil pressure switch input signal
Low coast brake oil pressure switch input signal
Low coast brake solenoid input signal
NOTE:
For details concerning the operation procedure, refer to the "SUBARU SELECT MONITOR OPERATION
MANUAL".
3. CLEAR MEMORY MODE
NOTE:
To clear the previous DTC, use {Clear Memory}, and to clear the learned value, use {Clear Memory 2}.
1) Check that the select lever is in "P" range.
2) On the «Main Menu» display screen, select the {Each System Check} and press the [YES] key.
3) On the «System Selection Menu» display screen, select the {Transmission Control System} and press the
[YES] key.
4) Press the [YES] key after the information of transmission type is displayed.
5) On the «Transmission Diagnosis» display screen, select the {Clear Memory} and press the [YES] key.
NOTE:
If {Clear Memory 2} is selected and performed, DTC are not cleared.
6) When 'Done' is shown on the display screen, turn off the Subaru Select Monitor and turn the ignition switch
to OFF. To turn the ignition switch to ON again, wait for more than 10 seconds.
NOTE:
For details concerning the operation procedure, refer to the "SUBARU SELECT MONITOR OPERATION
MANUAL".
Subaru Select Monitor
Item
5AT(diag)-18
Display
I/C Oil Pressure SW
LC/B Oil Pressure SW
LC B Solenoid
Unit of measure
ON or OFF
ON or OFF
ON or OFF