Subaru LEGACY 2006 Manual page 3390

asieps_tobira.book 38 ページ ２００９年１０月２６日 月曜日 午前９時１６分
AUTOMATIC TRANSMISSION
3) Install the engine mounting bolt (lower side).
Tightening torque:
50 N·m (5.1 kgf-m, 36.9 ft-lb)
4) Install the transmission rear crossmember.
Tightening torque:
75 N·m (7.6 kgf-m, 55.3 ft-lb)
5) Remove the transmission jack.
6) Lower the vehicle.
7) Install the engine mounting bolt (upper side).
Tightening torque:
50 N·m (5.1 kgf-m, 36.9 ft-lb)
8) Remove the ST from converter case.
ST 498277200 STOPPER SET
9) Install the starter. <Ref. to SC(H4SO)-6, IN-
STALLATION, Starter.>
Automatic Transmission Assembly
10) Install the torque converter to drive plate.
Tightening torque:
11) Remove the ST and install the pitching stopper
bracket.
Tightening torque:
AT-03238
12) Install the pitching stopper.
Tightening torque:
AT-01377
13) Lift-up the vehicle.
AT-03237
5AT-38
(1) Install the bolts which hold torque converter
to drive plate.
(2) Install all four bolts by rotating the crank pul-
ley a little at a time.
(3) Install the service hole.
25 N·m (2.5 kgf-m, 18 ft-lb)
40 N·m (4.1 kgf-m, 29.5 ft-lb)
T1: 50 N·m (5.1 kgf-m, 36.9 ft-lb)
T2: 58 N·m (5.9 kgf-m, 42.8 ft-lb)
T2
T1
AT-01369
AT-01380