Subaru LEGACY 2006 Manual page 3957

asieps_tobira.book 15 ページ ２００９年１０月２６日 月曜日 午前９時１６分
10) Tighten the castle nut to specified torque and
tighten further within 60° until the pin hole is aligned
with the slot in nut. Bend the cotter pin to lock.
(A)
(B)
(C)
(A) Cotter pin
(B) Castle nut
(C) Tie-rod
11) While depressing the brake pedal, tighten a
new axle nut (olive color) to the specified torque
and lock it securely.
Tightening torque:
220 N·m (22.4 kgf-m, 162 ft-lb)
CAUTION:
• Install the wheel after installation of axle nut.
Failure to follow this rule may damage the
wheel bearing.
• Be sure to tighten the axle nut to specified
torque. Do not overtighten it as this may dam-
age the wheel bearing.
12) After tightening the axle nut, lock it securely.
13) Install the wheel and tighten the wheel nuts to
specified torque.
Tightening torque:
110 N·m (11.2 kgf-m, 81.1 ft-lb)
Front Axle
C: DISASSEMBLY
1) Remove the four bolts from the housing, and re-
move the front hub unit bearing and disc cover.
DS-00042
(A) Housing
CAUTION:
• Do not get closer the tool which charged
magnetism to magnetic encoder.
• Be careful not to damage the magnetic en-
coder.
(1) Magnetic encoder
(2) Front hub unit bearing
2) Disassemble the front hub unit bearing. <Ref. to
DS-18, DISASSEMBLY, Front Hub Unit Bearing.>
DS-00048
DS-15
DRIVE SHAFT SYSTEM
(A)
(2)
(1)
DS-00231
DS-00250